I guess I was lucky because I spent a small fortune on equipment that does not have to do what he promised in the ads. Pure heart stop announcement ART SGX 2000 distortion has promised that he would bring, turned towards the purchase of one who could teach me difficult to get the sound track, I wanted to.
The situation is different today, guitar effects processors me disappoint systematically in the beginning, only to later surprise me when I learned the secret.
I think this is a given that most of the effects of guitar processors are at best mediocre when you listen to factory presets.
You will need to connect a decent guitar in the first, is just an inescapable fact, but this is not what I'm talking about ici.Je I am going to just to think that you have sorted.
The first key element is the basic distortion characteristics.Noise can be thin and uneventful, but if the underlying tone is the law of nature, it can be transformed into something great.
To illustrate this point, I have a distortion pedal Overdrive non-marque recommended by a friend.
He drew a Multi Ken multiple effects mem-7.See, I told you it is a trademark of non - name .this thing has the right tonal character but terrible sounds by the erroneous amplifier.
This is because many amplifiers are the two other very rock tone key ingredients.
That basically for me, is therefore the first step towards your dream rock acoustic guitar - guitar great survey into something that distorts the signal in the right way.
Delicate here is that it is difficult to determine if step one is correct that you have two steps and three.
There are two main frequencies I look when you try to get good tone déformé.Il is the lower and upper midrange frequencies.
Perhaps you've experienced this before, where you get a loud noise on your amplifier, then take the amp in a friends place to discover that for some strange reason it just does seem right over.
It is likely that there is a drop-down list box back open, but not necessarily.The only difference is that it is in another room, and each room has a different frequency response.
If I use a guitar with an open back Cabinet speaker amplifier, I would like to have installed near a wall for low ajouté.Dépendant speaker amplifier, it is not always necessary.
If you have a good amp with wide then you should worry too much on the frequencies and refinement, but if your amplifier has one of these horrible fuzzy distortion sound as the tube amp it supposed to emulate, then the following critical areas, you need to look at.
Your guitar amp has a loop effects?
If this is the case you have luck, cos now all you need is a small graphiqueUn equation with these regular eq pedals 10 band is enough, but you can also try a chart 7 band for this.
Figure 10 bands I would recommend is MXR M108 10-Band graphical equalizer pedal seeing that I have used myself, and has all the right frequency.
Low frequency:Here, I tend to promote spectrum located approximately 100 hz.Je 250 hz sometimes makes things sound a little too suitable, but it is always an option to add just a little bit, depending on the sound that is already out.
Upper midrange:Critical frequency here is 4 khz.Si noise is too vague, I take down all over 5 khz, and I mean right BAS.je replaces any upscale is missing with 4 khz.
If the noise gets too piercing, relaxation on the 4 k and adding back a little of the frequency of the upper end can help balance things again.
These are principles that work, if you're playing through a guitar amp or direct registration.
This entry was posted on November 18, 2008 at 16: 35 and is filed under the tone of the guitare.Vous can follow responses to this entry through the RSS 2.0.Vous feed can leave a response or trackback from your own site.
Tidak ada komentar:
Posting Komentar